It's an H950 from the 0 ebay deal. I am on ATT service and the phone worked fine at H95010d
I contacted ATT customer service and had them pushed OTA software update to me. The first agent pushed H95011x to me, and things went wrong since then.
The phone cannot read the sim card (but no missing sim notice), baseband shown as unknown, if I press the "status" under the "about phone" page, the screen will flash black then go back to the about phone page.
Then I tried a factory reset. The phone started normal as if everything was fine, it just works on the first boot after the reset. But once I restart the phone, it went back to the same situation as above. I tried many times and the whole process is highly repeatable.
After that, I contacted ATT again, had the H95011z pushed to me, and it did not change the problem. Replacing sim card does not help, either.
Then I tried to get to those recovery methods on the forum, including installing the LGE mobile device drivers. But then under download mode, the phone (LGE Android MTP device) is shown as "this device cannot start (code 10)". Thus I was not able to perform fix with the tools.
I am kinds of stuck in the middle. Any help and/or suggestions would be appreciated. Thanks!
I contacted ATT customer service and had them pushed OTA software update to me. The first agent pushed H95011x to me, and things went wrong since then.
The phone cannot read the sim card (but no missing sim notice), baseband shown as unknown, if I press the "status" under the "about phone" page, the screen will flash black then go back to the about phone page.
Then I tried a factory reset. The phone started normal as if everything was fine, it just works on the first boot after the reset. But once I restart the phone, it went back to the same situation as above. I tried many times and the whole process is highly repeatable.
After that, I contacted ATT again, had the H95011z pushed to me, and it did not change the problem. Replacing sim card does not help, either.
Then I tried to get to those recovery methods on the forum, including installing the LGE mobile device drivers. But then under download mode, the phone (LGE Android MTP device) is shown as "this device cannot start (code 10)". Thus I was not able to perform fix with the tools.
I am kinds of stuck in the middle. Any help and/or suggestions would be appreciated. Thanks!
No comments:
Post a Comment